Installation Manual

INS_CNGE2+2SMS_REV–
02/19/13 PAGE 31
INSTALLATION AND OPERATION MANUAL CNGE2+2SMS[POE][HO]
TECH SUPPORT: 1.888.678.9427
Firmware Upgrade Procedure
Push Bootloader Image Uploader interface
The steps for upgrading the unit with the push boot loader are as follows;
1. Bring up the web server and open the FileSystem Upload page click the Enable Image
upload check box and hit apply.
2. Open the Windows bootloader application, click the enable Ethernet check box and adjust
the IP address to the target IP
3. Click the “Load Hex File” and select the new firmware file.
- Click Erase
- Click Program
- Click Verify
- Click run application
Note: The “Erase-Program-Verify” button is not supported at this time. Please use the
individual buttons.