System information

INS_CNGE2FE8MSPOE+_REV–
12/20/12 PAGE 26
INSTALLATION AND OPERATION MANUAL CNGE2FE8MSPOE+
TECH SUPPORT: 1.888.678.9427
IP Setting
You can configure the IP Settings and DHCP client function through IP configuration.
IP Configuration interface
Label Description
DHCP Client To enable or disable the DHCP client function. When DHCP client
function is enabling, the switch will be assigned the IP address from the
network DHCP server. The default IP address will be replaced by the
IP address that the DHCP server has assigned. After selecting Apply
button, a popup dialog shows up to inform when the DHCP client is
enabling. The current IP will lose and you should find a new IP on the
DHCP server.
IP Address Assign the IP address that the network is using. If the DHCP client
function is enabled, you do not need to assign the IP address. The
network DHCP server will assign the IP address for the switch and it will
be display in this column. The default IP is 192.168.10.1
Subnet Mask Assign the subnet mask of the IP address. If DHCP client function is
enabling, you do not need to assign the subnet mask
Gateway Assign the network gateway for the switch. The default gateway is
192.168.10.254
DNS1 Assign the primary DNS IP address
DNS2 Assign the secondary DNS IP address
Apply Select Apply to activate the configurations.