Datasheet

INS_CNVETX1_REV– 06/10/13 PAGE 88
INSTALLATION AND OPERATION MANUAL CNVETX1
TECH SUPPORT: 1.888.678.9427
› Enable Traps: Check to enable sending standard and enterprise traps
› Trap Receiver (1) IP Address: Traps destination 1 (Mandatory)
› Trap Receiver (2) IP Address: Traps destination 2 (Optional)
› Trap Receiver (3) IP Address: Traps destination 3 (Optional)
› Trap community: User configurable (Default: public)
› Cold Start trap: Signifies that the encoder is reinitializing itself and that its configuration may
have been altered
› Warm Start trap: Signifies that the encoder is reinitializing itself such that its configuration is
unaltered
› Link Up trap: Signifies that the encoder has a live Network Interface
› VideoExists trap: Signifies a state change of the video input signal
› Digital In0 trap: Signifies a state change of digital input#0 (TTL #0)
› Digital In1 trap: Signifies a state change of digital input#1 (TTL #1)
› CPU usage threshold: CPU threshold value (90% Def.)
› CPU Load (over threshold) trap: Signifies the CPU usage threshold (%) was exceeded
› DSP usage threshold: DSP threshold value (90% Def.)
› DSP Load (over threshold) trap: Signifies the DSP usage threshold (%) was exceeded
5. Select Save to apply the settings.
Figure 85: SNMP Traps Settings