User Manual

68
7.7.4 ACL
An ACL is a sequential list of permit or deny conditions that apply to IP addresses. This
switch tests ingress or egress packets against the conditions in an ACL one by one. A
packet will be accepted as soon as it matches a permit rule, or dropped as soon as it
matches a deny rule. If no rules match for a list of all permit rules, the packet is dropped; and
if no rules matches for a list of all deny rules, the packet is accepted.
The following restrictions apply to ACLs:
 The ACL only support single port and not support trunk group.
 The maximum number of ACLs is also 5 for each port.
Command Attributes
 Enable: An ACL can be enabled per port.
 Default Action: The action if no rules matched.
 Action: An ACL can be permit or deny rule.
 IP Address and Prefix Length: Include destination and source IP address.
Ex: source 192.168.10.1/24 means all frames that source IP address is 192.168.10.x
matched.
Access Control Configuration Interface