Installation Manual
Table Of Contents
- About This Guide
- Overview
- Hardware Overview
- Ethernet Cables
- WEB Management
- Configuration by Web Browser
- About Web-based Management
- Basic Setting
- System Information
- Admin & Password
- Auth Method
- IP Setting
- HTTPS
- SSH
- LLDP
- Backup/Restore Configuration
- Firmware Update
- DHCP Server
- Port Setting
- Port Trunk
- LACP
- Redundancy
- MSTP
- STP
- VLAN
- VLAN Setting Example
- SNMP
- Traffic Prioritization
- Multicast
- Security
- AAA
- RADIUS Overview
- Warning
- System Warning
- Monitor and Diag
- Port Statistic
- System Log Information
- Cable Diagnostics
- SFP Monitor
- Ping
- Syncronization-PTP
- PoE Configuration
- Status
- Factory Defaults
- System Reboot
- Configuration by Web Browser
- Command Line Interface Management
- Technical Specifications
INS_CWGE26FX2TX24MSPOE_REV– 5 Mar 2014 PAGE 106
INSTALLATION AND OPERATION MANUAL CWGE26FX2TX24MSPOE
TECH SUPPORT: 1.888.678.9427
Short frames are frames that are smaller than 64 bytes.
Long frames are frames that are longer than the configured maximum frame length for this port.
Port Monitoring
Configure port Mirroring on this page.
To debug network problems, selected traffic can be copied, or mirrored, to a mirror port where a
frame analyzer can be attached to analyze the frame flow.
The traffic to be copied to the mirror port is selected as follows:
All frames received on a given port (also known as ingress or source mirroring).
All frames transmitted on a given port (also known as egress or destination mirroring).
Port to mirror also known as the mirror port. Frames from ports that have either source (rx) or
destination (tx) mirroring enabled are mirrored to this port. Disabled disables mirroring.
Label Description
Port The logical port for the settings contained in the same row.
Mode Select mirror mode.
Rx only : Frames received at this port are mirrored to the mirror port. Frames
transmitted are not mirrored.
Tx only :Frames transmitted from this port are mirrored to the mirror port. Frames
received are not mirrored.
Disabled : Neither frames transmitted nor frames received are mirrored.
Enabled : Frames received and frames transmitted are mirrored to the mirror port.
Note: For a given port, a frame is only transmitted once. It is therefore not possible to
mirror Tx frames for the mirror port. Because of this, mode for the selected mirror port
is limited to Disabled or Rx only.