Installation Manual
Table Of Contents
- About This Guide
- Overview
- Hardware Overview
- Ethernet Cables
- WEB Management
- Configuration by Web Browser
- About Web-based Management
- Basic Setting
- System Information
- Admin & Password
- Auth Method
- IP Setting
- HTTPS
- SSH
- LLDP
- Backup/Restore Configuration
- Firmware Update
- DHCP Server
- Port Setting
- Port Trunk
- LACP
- Redundancy
- MSTP
- STP
- VLAN
- VLAN Setting Example
- SNMP
- Traffic Prioritization
- Multicast
- Security
- AAA
- RADIUS Overview
- Warning
- System Warning
- Monitor and Diag
- Port Statistic
- System Log Information
- Cable Diagnostics
- SFP Monitor
- Ping
- Syncronization-PTP
- PoE Configuration
- Status
- Factory Defaults
- System Reboot
- Configuration by Web Browser
- Command Line Interface Management
- Technical Specifications
INS_CWGE26FX2TX24MSPOE_REV– 5 Mar 2014 PAGE 117
INSTALLATION AND OPERATION MANUAL CWGE26FX2TX24MSPOE
TECH SUPPORT: 1.888.678.9427
Command Line Interface Management
About CLI Management
In addition to WEB-base management, the CWGE26FX2TX24MSPOE also supports CLI
management. You can use console or telnet to management the switch by CLI.
CLI Management by RS-232 Serial Console (115200, 8, none, 1, none)
Before Configuring by RS-232 serial console, use an DB-9-M to DB-9-F cable to connect the
switches’ RS-232 Console port to your PC COM port.
Follow the steps below to access the console via RS-232 serial cable.
Step 1. From the Windows desktop, Select Start – > Programs – > Accessories – > Communications
– > Hyper Terminal