Installation Manual
Table Of Contents
- About This Guide
- Overview
- Hardware Overview
- Ethernet Cables
- WEB Management
- Configuration by Web Browser
- About Web-based Management
- Basic Setting
- System Information
- Admin & Password
- Auth Method
- IP Setting
- HTTPS
- SSH
- LLDP
- Backup/Restore Configuration
- Firmware Update
- DHCP Server
- Port Setting
- Port Trunk
- LACP
- Redundancy
- MSTP
- STP
- VLAN
- VLAN Setting Example
- SNMP
- Traffic Prioritization
- Multicast
- Security
- AAA
- RADIUS Overview
- Warning
- System Warning
- Monitor and Diag
- Port Statistic
- System Log Information
- Cable Diagnostics
- SFP Monitor
- Ping
- Syncronization-PTP
- PoE Configuration
- Status
- Factory Defaults
- System Reboot
- Configuration by Web Browser
- Command Line Interface Management
- Technical Specifications
INS_CWGE26FX2TX24MSPOE_REV– 5 Mar 2014 PAGE 47
INSTALLATION AND OPERATION MANUAL CWGE26FX2TX24MSPOE
TECH SUPPORT: 1.888.678.9427
VLAN
VLAN Membership Configuration
The VLAN membership configuration for the selected stack switch unit switch can be monitored
and modified here. Up to 64 VLANs are supported. This page allows for adding and deleting
VLANs as well as adding and deleting port members of each VLAN.
Label Description
Delete Check to delete the entry. It will be deleted during the next save.
VLAN ID The VLAN ID for the entry.
MAC Address The MAC address for the entry.
Port Members Check marks indicate which ports are members of the entry. Check or uncheck as
needed to modify the entry.
Adding a New
Static Entry
Click Add New VLAN to add a new VLAN ID. An empty row is added to the table, and
the VLAN can be configured as needed. Legal values for a VLAN ID are 1 through
4095.
The VLAN is enabled on the selected stack switch unit when you click on Save. The
VLAN is thereafter present on the other stack switch units, but with no port members.
A VLAN without any port members on any stack unit will be deleted when you click
Save.
The Delete button can be used to undo the addition of new VLANs.