Installation Manual
Table Of Contents
- About This Guide
- Overview
- Hardware Overview
- Ethernet Cables
- WEB Management
- Configuration by Web Browser
- About Web-based Management
- Basic Setting
- System Information
- Admin & Password
- Auth Method
- IP Setting
- HTTPS
- SSH
- LLDP
- Backup/Restore Configuration
- Firmware Update
- DHCP Server
- Port Setting
- Port Trunk
- LACP
- Redundancy
- MSTP
- STP
- VLAN
- VLAN Setting Example
- SNMP
- Traffic Prioritization
- Multicast
- Security
- AAA
- RADIUS Overview
- Warning
- System Warning
- Monitor and Diag
- Port Statistic
- System Log Information
- Cable Diagnostics
- SFP Monitor
- Ping
- Syncronization-PTP
- PoE Configuration
- Status
- Factory Defaults
- System Reboot
- Configuration by Web Browser
- Command Line Interface Management
- Technical Specifications
INS_CWGE26FX2TX24MSPOE_REV– 5 Mar 2014 PAGE 6
INSTALLATION AND OPERATION MANUAL CWGE26FX2TX24MSPOE
TECH SUPPORT: 1.888.678.9427
Overview
Introduction
The CWGE26FX2TX24MSPOE Gigabit managed redundant ring PoE Ethernet switch with
22x10/100/1000Base-T(X) IEEE802.3at PSE ports and two Gigabit combo IEEE802.3at PSE ports
and 2x100/1000Base-X SFP ports supports Ethernet Redundancy protocol, C-Ring (recovery
time < 30ms over 250 units of connection) and MSTP (RSTP/STP compatible). It can protect your
mission-critical applications from network interruptions or temporary malfunctions with its fast
recovery technology. The CWGE26FX2TX24MSPOE also supports Power over Ethernet (PoE+),
a system to transmit electrical power up to 30 watts, along with data, to remote devices over
standard twisted-pair cable in an Ethernet network.