Installation Manual
Table Of Contents
- About This Guide
- Overview
- Hardware Overview
- Ethernet Cables
- WEB Management
- Configuration by Web Browser
- About Web-based Management
- Basic Setting
- System Information
- Admin & Password
- Auth Method
- IP Setting
- HTTPS
- SSH
- LLDP
- Backup/Restore Configuration
- Firmware Update
- DHCP Server
- Port Setting
- Port Trunk
- LACP
- Redundancy
- MSTP
- STP
- VLAN
- VLAN Setting Example
- SNMP
- Traffic Prioritization
- Multicast
- Security
- AAA
- RADIUS Overview
- Warning
- System Warning
- Monitor and Diag
- Port Statistic
- System Log Information
- Cable Diagnostics
- SFP Monitor
- Ping
- Syncronization-PTP
- PoE Configuration
- Status
- Factory Defaults
- System Reboot
- Configuration by Web Browser
- Command Line Interface Management
- Technical Specifications
INS_CWGE26FX2TX24MSPOE_REV– 5 Mar 2014 PAGE 86
INSTALLATION AND OPERATION MANUAL CWGE26FX2TX24MSPOE
TECH SUPPORT: 1.888.678.9427
RADIUS Authentication Server Configuration
The table has one row for each RADIUS Authentication Server and a number of columns, which
are:
Label Description
# The RADIUS Authentication Server number for which the configuration below applies.
Enabled Enable the RADIUS Authentication Server by checking this box.
IP Address The IP address or hostname of the RADIUS Authentication Server. IP address is
expressed in dotted decimal notation.
Port The UDP port to use on the RADIUS Authentication Server. If the port is set to 0 (zero),
the default port (1812) is used on the RADIUS Authentication Server.
Secret The secret – up to 29 characters long – shared between the RADIUS Authentication
Server and the switch stack.
RADIUS Accounting Server Configuration
Label Description
# The RADIUS Accounting Server number for which the configuration below applies.
Enabled Enable the RADIUS Accounting Server by checking this box.
IP Address The IP address or hostname of the RADIUS Accounting Server. IP address is expressed
in dotted decimal notation.
Port The UDP port to use on the RADIUS Accounting Server. If the port is set to 0 (zero), the
default port (1813) is used on the RADIUS Accounting Server.
Secret The secret – up to 29 characters long – shared between the RADIUS Accounting Server
and the switch stack.