Installation Manual

INS_FVR1C1B_REV–

12/06/10

PAGE 1

INSTALLATION AND OPERATION MANUAL

FVR1C1B(M,S)1

8-BIT DIGITALLY ENCODED VIDEO RECEIVER

WITH CONTACT CLOSURE

The FVR1C1B receives one channel of video and contact closure over optical

fiber utilizing state-of-the-art 8-bit digital decoding for high-quality video

transmission. These units are completely transparent to and universally

compatible with any NTSC, PAL, or SECAM CCTV camera systems. Plug-and-

play design ensures ease of installation and no electrical or optical adjustments

are ever required.

Bi-color (Red/Green) LED indicators are provided for rapidly ascertaining

equipment operating status. See Figure 4 on Page 3 for an explanation of LED

indicators.

These units may be either wall or rack-mounted, or may be DIN-rail mounted by

the addition of ComNet model DINBKT1 adaptor plate. See Figure A on Page 4

mounting instructions.

See Figures 1 – 3 for complete installation details.

PAGE 1
INSTALLATION AND OPERATION MANUAL FVR1C1B(M,S)1 8-bit digitalLY ENCODED video receiver with contact closure The FVR1C1B receives one channel of video and contact closure over optical fiber utilizing state-of-the-art 8-bit digital decoding for high-quality video transmission. These units are completely transparent to and universally compatible with any NTSC, PAL, or SECAM CCTV camera systems. Plug-andplay design ensures ease of installation and no electrical or optical adjustments are ever required.
PAGE 2
INSTALLATION AND OPERATION MANUAL FVR1C1B(M,S)1 FIGURE 1 – FVR1C1B1 RECEIVER MULTIMODE OR SINGLE MODE OPTICAL FIBERS BLACK (GND) BLACK WITH WHITE STRIPE (8 – 15VDC) FIGURE 3 – FVR1C1B1 RECEIVER FRONT PANEL REAR PANEL NOTE: Remove Electrical Connector for Rack Mount Units Tech Support: 1.888.678.
PAGE 3
INSTALLATION AND OPERATION MANUAL FVR1C1B(M,S)1 FIGURE 3 – LED INDICATORS VIDEO CONTACT GREEN Video signal is present Contact Closed RED No video signal is present – OFF – Contact Open FIGURE 4 – CONTACT SETTINGS Open Circuit ≤ 30 VDC Closed Current ≤ 500 mA Contact GROUND Tech Support: 1.888.678.
PAGE 4
MECHANICAL INSTALLATION INSTRUCTIONS Installation Considerations This fiber-optic link is supplied as a Standalone/Rack module. Units should be installed in dry locations protected from extremes of temperature and humidity. C1-US, C1-EU, C1-AU or C1-CH Card Cage Racks Figure A Dimensions are for a standard ComNet one slot module .156 [3.