Installation Manual

INS_FVT/FVR4012_REV–
02/29/12
PAGE 5
TECH SUPPORT: 1.888.678.9427
INSTALLATION AND OPERATION MANUAL FVT/FVR4012
FIGURE 7 – LED INDICATORS
FIGURE 6 – CONTACT SWITCH POSITIONS
LINK VIDEO (1 – 4) DATA (1 – 2) POWER
GREEN Communication link has been
established over optical fiber
Active video signal present on
the BNC connector.
Active data signal present Unit powered up
RED Communication link has not been
established
No video signal No data signal –
OFF Not powered up correctly – – Unit powered down
The four CONTACT switches on the front of the unit set the operating mode of the
CONTACT OUT terminal pair.
It can either function as an alarm to indicate fault conditions, or it can function as a
contact closure to indicate the state of the CONTACT IN terminal pair on the rear of
the unit at the other end of the fiber.
1 2 3 4
ON OFF OFF OFF Closed when optical Port has established link.
Open when Optical Port has lost link.
ON ON ON OFF Closed when Optical Port has established link and all video signals are present.
Open when Optical Port has lost Link, or if a Video signal is lost.
ON ON ON ON Contact Closure mode.
State based on CONTACT IN at other end of fiber link.