Data Sheet

LIFETIME WARRANTY WWW.COMNET.NET TECH SUPPORT: 1.888.678.9427

FEATURES

› 10-bit Digital Video, Contact Closure Transmission: Receives

one, two, or four real-time color video signals over one, two,

or four optical fibers

› Supports one, two or four Contact Closures in the direction

of video, ideal for tamper switch, etc.

› Exceptionally low video distortion with zero performance

variation vs. optical path

› Distances up to 4 km (2.5 mi) over Multimode Fiber

› Distances up to 54 km (33.6 mi) over Single Mode Fiber

› Exceeds All Requirements for EIA RS-250C Short-Haul

Transmission Specifications

› › Compatible with NTSC, PAL, or SECAM Video Standards

› NTCIP compatible

› Designed to meet NEMA TS 1/TS 2 and Caltrans Traffic

Signal Control Equipment Environmental Standards

› Voltage transient protection on all power and signal input/

output lines provides protection from power surges and other

voltage transient events.

› Bi-color (Red/Green) LED status indicators provide rapid

indication of critical operating parameters

› Automatic resettable fuses on all power lines

› Hot-Swappable Modules

› 12VDC or 24VAC powered FVT10C1/M mini unit can be

powered directly from camera

› ComFit units are interchangeable between stand-alone or

rack mount use

› Lifetime Warranty

The ComNet

™

series video transmitters and receivers support the transmission of

one, two, or four independent short-haul quality 10-bit digital video signals and one,

two, or four contact closures in the direction of the video over multimode or single

mode optical fibers. This module is universally compatible with major CCTV camera

manufacturers. The receivers are compatible with the FVT10C1(M,S)1[/M] series or

FVT1(M,S)1/M* single channel transmitters. Plug-and-play design ensures ease of

installation and no electrical or optical adjustments are ever required.

FVT/FVR10C1(M,S)1[/M], FVR20C2(M,S)2, and FVR40C4(M,S)4

Single, Dual or Quad-Channel 10-Bit Digitally Encoded

Short-Haul Video and Contact Closure

1, 2 OR 41, 2 OR 4INCLUDED

* FVT1(M,S)1/M not available in North America.

PAGE 1
Single, Dual or Quad-Channel 10-Bit Digitally Encoded Short-Haul Video and Contact Closure FVT/FVR10C1(M,S)1[/M], FVR20C2(M,S)2, and FVR40C4(M,S)4 INCLUDED 1, 2 OR 4 1, 2 OR 4 The ComNet™ series video transmitters and receivers support the transmission of one, two, or four independent short-haul quality 10-bit digital video signals and one, two, or four contact closures in the direction of the video over multimode or single mode optical fibers.
PAGE 2
Single, Dual or Quad-Channel 10-Bit Digitally Encoded Short-Haul Video and Contact Closure FVT/FVR10C1(M,S)1[/M], FVR20C2(M,S)2, and FVR40C4(M,S)4 SPECIFICATIONS LED Indicators Video1 Video Input 1 volt pk-pk (75 ohms) Overload >1.5V pk-pk Bandwidth 5 Hz - 10 MHz Differential Gain <2% Differential Phase <0.7º Tilt <1% Signal-to-Noise Ratio (SNR) >60 dB typical @ Max. Optical Loss Budget Max.