Installation Manual

INS_FVT/FVR120_REVA
05/06/10
PAGE 1
INSTALLATION AND OPERATION MANUAL
FVT/FVR120(M)(S)1
12-CHANNEL DIGITALLY ENCODED VIDEO
The FVT/FVR120 is a twelve (12) channel ten (10) bit digitally encoded video
transmission system. It combines twelve individual video signals into one
high speed digital stream and transmits this over a one optical fiber. The
FVT/FVR120 consists of a twelve channel video transmitter (FVT120) and a
twelve Channel video receiver (FVR120).
The outputs of the modules are combined at the transmitter into a single
optical signal by means of the WDM and separated out at the receiver with an
identical WDM. While the WDM has provision for five (5) different wavelengths
(colors), in this application only two wavelengths are used.
The video channels are referred to as A1, A2, etc. and B1, B2, etc. A video
input to the A3 transmitter BNC connector will be received out of the A3 BNC
on the corresponding video module.
The FVT120 and the FVR120 come completely assembled and tested from the
factory. There are no optical or electrical adjustments required or permitted.
See Figures 1 – 5 for complete installation instructions.