Installation Manual

INS_FVT/FVR160_REVA
05/06/10
PAGE 1
INSTALLATION AND OPERATION MANUAL
FVT/FVR160(M)(S)1
16-CHANNEL DIGITALLY ENCODED VIDEO
The FVT/FVR160 is a sixteen (16) channel ten (10) bit digitally encoded video
transmission system. It combines sixteen individual video signals into one
high speed digital stream and transmits this over a one optical fiber. The FVT/
FVR160 consists of a sixteen channel video transmitter (FVT160) and a sixteen
Channel video receiver (FVR160).
The outputs of the 8 Channel Video Modules are combined at the transmitter
into a single optical signal by means of the WDM and separated out at the
receiver with an identical WDM. While the WDM has provision for five (5) different
wavelengths (colors), in this application only two wavelengths are used.
The video channels are referred to as A1, A2, etc. and B1, B2, etc. A video
input to the A3 transmitter BNC connector will be received out of the A3 BNC
on the corresponding video module.
The FVT160 and the FVR160 come completely assembled and tested from the
factory. There are no optical or electrical adjustments required or permitted.
See Figures 1 – 5 for complete installation instructions.