Installation Manual

INS_FVT1C1B_REV–

12/06/10

PAGE 1

INSTALLATION AND OPERATION MANUAL

FVT1C1B(M,S)1-M

8-BIT DIGITALLY ENCODED VIDEO MINI TRANSMITTER

WITH CONTACT CLOSURE

The FVT1C1B-M video mini-transmitter supports transmission of a fixed video and

a contact closure signal using an 8-bit digitally encoded signal on one multimode

or single mode fiber optic cable. These units are completely transparent to and

universally compatible with any NTSC, PAL, or SECAM CCTV camera systems.

The FVT1C1B-M video transmitter is compatible with the FVR4C4B receivers.

Installation requires no electrical or optical adjustments.

The transmitter incorporates a bi-color (Red/Green) indicating LED for monitoring

proper system operation.

The unit operates on 5VDC power.

The FVT1C1B mini unit operates as a standalone module only.

See Figures 1 – 3 for complete installation details.

PAGE 1
INSTALLATION AND OPERATION MANUAL FVT1C1B(M,S)1-M 8-BIT DIGITALLY ENCODED VIDEO MINI TRANSMITTER WITH CONTACT CLOSURE The FVT1C1B-M video mini-transmitter supports transmission of a fixed video and a contact closure signal using an 8-bit digitally encoded signal on one multimode or single mode fiber optic cable. These units are completely transparent to and universally compatible with any NTSC, PAL, or SECAM CCTV camera systems. The FVT1C1B-M video transmitter is compatible with the FVR4C4B receivers.
PAGE 2
INSTALLATION AND OPERATION MANUAL FVT1C1B(M,S)1-M FIGURE 1 – FVT1C1B(M,S)1-M 5VDC INPUT +5V Center GND Shield MULTIMODE OR SINGLE MODE OPTICAL FIBER FIGURE 2 – FVT1C1B(M,S)1-M FRONT PANEL FIGURE 3 – LED INDICATOR REAR PANEL VIDEO PRESENT GREEN A Video signal is present. RED No Video signal is present. OFF Unit not powered up. FIGURE 4 – CONTACT SETTINGS Open Circuit 3.3V Current Sink to Close ≤ 1mA CONTACT GROUND TECH SUPPORT: 1.888.678.
PAGE 3
MECHANICAL INSTALLATION INSTRUCTIONS INSTALLATION CONSIDERATIONS This fiber-optic link is supplied as a Standalone module. Units should be installed in dry locations protected from extremes of temperature and humidity. FIGURE A Dimensions are for a standard ComNet™ “mini” module WARNING: Unit is to be used with a Listed Class 2 or LPS power supply rated 5 VDC @ 1A.