Installation Manual

ManualsBrandsComnet ManualsFiber Optic Transmission4-Channel Digitally Encoded Video Transmitter

INS_FVT/FVR41_REV–

01/27/10

PAGE 1

INSTALLATION AND OPERATION MANUAL

Value Line

FVT/FVR41

4-CHANNEL DIGITAL VIDEO MULTIPLEXER

The FVT/FVR41 is a four (4) channel video transmission system. It combines

four individual video signals into one high speed digital stream and transmits

this over one optical fiber.

These units may be directly plugged into the ComNet Rack (Part C1) or they

can operate as standalone modules. See Figure A on Page 4 for mounting

instructions.

See Figures 1 – 4 for complete installation details.

Summary of content (4 pages)

PAGE 1
INSTALLATION AND OPERATION MANUAL Value Line FVT/FVR41 4-CHANNEL DIGITAL VIDEO MULTIPLEXER The FVT/FVR41 is a four (4) channel video transmission system. It combines four individual video signals into one high speed digital stream and transmits this over one optical fiber. These units may be directly plugged into the ComNet Rack (Part C1) or they can operate as standalone modules. See Figure A on Page 4 for mounting instructions. See Figures 1 – 4 for complete installation details.
PAGE 2
INSTALLATION AND OPERATION MANUAL FVT/FVR41 FIGURE 1 – FVT/FVR41 TRANSMITTER AND RECEIVER MULTIMODE OR SINGLE MODE OPTICAL FIBER BLACK BLACK WITH WHITE STRIPE FIGURE 2 – FVT41 TRANSMITTER FIGURE 3 – FVR41 RECEIVER FRONT PANEL FRONT PANEL REAR PANEL REAR PANEL NOTE: Remove Electrical Connector for Rack Mount Units TECH SUPPORT: 1.888.678.
PAGE 3
INSTALLATION AND OPERATION MANUAL FVT/FVR41 FIGURE 4 – LED INDICATORS GREEN RED LINK VIDEO (1 – 4) POWER Communication link has An active video signal is Unit powered up been established over present on the BNC optical fiber connector. Communication link has No video signal – not been established. OFF Not powered up correctly – TECH SUPPORT: 1.888.678.
PAGE 4
MECHANICAL INSTALLATION INSTRUCTIONS INSTALLATION CONSIDERATIONS This fiber-optic link is supplied as a Standalone/Rack module. Units should be installed in dry locations protected from extremes of temperature and humidity. C1-US, C1-EU, C1-AU OR C1-CH CARD CAGE RACKS FIGURE A Dimensions are for a standard ComNet™ one slot module .156 [3.