Installation Manual

INS_NW1_NW2_QS_REV– 05/20/13 PAGE 5
INSTALLATION REQUIREMENTS
CONFIGURING NETWAVE
QUICK START USER GUIDE NW1/NW2
TECH SUPPORT: 1.888.678.9427
Shielded CAT 5 or better should be used for all out of plant Ethernet connection and should be properly grounded through the
PoE AC ground. Industrial grade shielded Ethernet cable is recommended to help prevent ESD damage commonly experienced
with outdoor installations. Visit www.comnet.net/comnet-products/cables
1. Connect an Ethernet cable from the port labelled as IN on the power Injection Module to either a laptop or a PC LAN port.
2. Connect the second Ethernet cable from the OUT port on the Power Injection Module to the Netwave LAN port.
3. Apply 24VDC to the Power Injection Module with the provided power supply. You should notice the green LED illuminate in
the Power Injection Module and the power LED on the Netwave unit.
4. Set the IP address of the laptop being used to configure Netwave to static and the subnet to 192.168.10.x/24 subnet.
5. Point the browser to 192.168.10.101. This is the default address.
6. A login prompt will pop up. Enter:
ID: admin
Password: admin
7. Select the NETWORK SETTINGS tab and set the desired network settings.
Hit Apply Settings
Hit Save
NOTE: This will be the network address for the NetWave web server. It is not necessary to set to the same subnet as the
operating network but it is recommended.
8 Select the WIRELESS SETTINGS tab and set:
• Wireless mode – Set to AP or Client (Only need to do this on the NW1 and NW2 models)
• Country code – Only required if setting up the NW2 and NWK2 (ETSI) models
NOTE: It is the user’s responsibility to ensure that the correct country is chosen. ComNet accepts no liability for incorrectly set
up equipment.
• Output RF power – if RSSI is greater than 70, it is recommended to reduce RF TX power.
• Set SSID – if changing from the default setting
• Channel Spectrum Width – May want to reduce to 20M from the default 20/40M if the 5GHz spectrum is crowded
• Wireless Security – if changing from default settings
• Hit Apply Settings
• Hit Save