Installation Manual

INS_NW1_NW2_QS_REV– 05/20/13 PAGE 6TECH SUPPORT: 1.888.678.9427
QUICK START USER GUIDE NW1/NW2
DEFAULT CONFIGURATIONS
IP Address of Web Server 192.168.10.100 for NWKx_AP and 192.168.10.101 for all other models
LAN Mode for Web Server Static Addressing
Web Server User ID admin
Web Server Password admin
Web Server Guest User ID guest
Webserver Guest Password guest
SSID Netwave-1
WPA Pre-shared Key 12345678
Channel-Frequency (AP) Auto
Channel Spectrum Width 20/40M
Long Range Parameters Enabled and defaulted to 1000m
NOTE: A Reset to defaults (performed on the ADMIN page) will erase all user configurations including the factory set MAC lock on
Point to Point (NWKx) models.
TYPICAL POINT-TO-POINT CONFIGURATION
TYPICAL POINT-TO-MULTIPOINT CONFIGURATION
NOTE: NW1 and NW2 Multipoint nodes will need to have the Wireless Mode set to either AP or Client (default is Client). And
the IP addresses will need to be all set to different addresses (default address is 192.168.10.101). Once this is done, all
the clients will connect to the multipoint AP with all other setting kept at default.
NOTE: NWK1 and NWK2 point to point kits have been set up at the factory and locked to each other. No need to set Wireless
Mode and may not need to set the IP address. These are designed to connect to each other once powered and properly
aligned.
Passive
Power
Injector
Passive
Power
Injector
Passive
Power
Injector
NW1
(Client)
IP
Camera
NW1
(Client)
IP
Camera
NW1
(Client)
IP
Camera
PC DVR
Cat5 Cable
CNGE2FE8MS
Managed
Switch
NW1
(Access Point)
Passive
Power
Injector
Passive
Power
Injector
NWK1
(Client)
IP
Camera
PC DVR
Cat5 Cable
CNGE2FE8MS
Managed
Switch
NWK1
(Access Point)
Passive
Power
Injector