Quick Start Guide

INS_NW1M_NW2M_QS_REV– 07/7/15 PAGE 7TECH SUPPORT: 1.888.678.9427
QUICK START USER GUIDE NW(1,2)/M
DEFAULT CONFIGURATIONS
IP Address of Web Server 192.168.10.101
LAN Mode for Web Server Static Addressing
Web Server User ID admin
Web Server Password admin
SSID NetWave-1
WPA Pre-shared Key 12345678
Channel-Frequency (AP) Auto
Channel Spectrum Width 20/40M
Long Range Parameters Enabled and defaulted to 1000m
NOTE: A Reset to defaults (performed on the ADMIN page or via the RESET button) will erase all user configurations.
TYPICAL POINT-TO-POINT CONFIGURATION
TYPICAL POINT-TO-MULTIPOINT CONFIGURATION
NOTE: NW1/M and NW2/M Multipoint nodes will need to have the Wireless Mode set to either AP or Client (default is Client).
And the IP addresses will need to be all set to different addresses (default address is 192.168.10.101). Once this is
done, all the clients will connect to the multipoint AP with all other settingst kept at default.
PIM
or other
PSE device
PIM
or other
PSE device
PIM
or other
PSE device
NW1/M
(Set to Client)
IP
Camera
NW1/M
(Set to Client)
IP
Camera
NW1/M
(Set to Client)
IP
Camera
PIM
or other
PSE device
NW1/M
(Set to Client)
IP
Camera
PC NVR
Cat5 Cable
10/100Mbps
ComNet Gigabit
Managed Switch
with 30W PoE+
NW1/M
(Set to Access Point)
PoE
PC NVR
Cat5 Cable
10/100Mbps
ComNet Gigabit
Managed Switch
with 30W PoE+
NW1/M
(Set to Access Point)
(IA870 option recommended)
PoE