Users Manual

INS_NetWave_REV– 06/10/13 PAGE
16
INSTALLATION AND OPERATION MANUAL
NETWAvE
TX Rate Shows the transmit bit rate from the AP towards this Client.
Associated Stations
This section shows the connected devices, if the Radio works.
Figure 6: List of Associated Stations.
If there are no associated Clients, the text “No information available” is displayed. The parameters
shown are as follows:
MAC‐Address
Displays the MAC address of the station's radio.
Network
States the name of the wireless network.
Signal
Displays the received signal strength from the Client e.g. ‐26 dBm.
Noise
Displays the received noise power at the AP.
RSSI/Chains
Shows the received signal strengths from the station on each antenna e.g. ‐42, ‐26 dBm. The
value of ‐95 dBm is taken to mean “no antenna” if the radio has only 2 antennas. Values
inside of the parenthesis show the vertical and horizontal polarities. large difference can
indicate a Line of Sight or Noise issue.
TX‐CCQ
Indicates the wireless connection quality.
RX Rate Shows the receive bit rate at the AP from this Client.
HT Mode
Displays Channel Spectrum Width
Up Time Display time since last reboot