Instruction Manual

INS_NetWave_REV– 06/10/13 PAGE 19
INSTALLATION AND OPERATION MANUAL NETWAvE
TECH SUPPORT: 1.888.678.9427
9.5 Associated Stations (for AP Mode)
This section shows the connected devices, if the Radio is in the AP mode.
Figure 7: List of Associated Stations.
If there are no associated Clients, the text “No information available” is displayed. The parameters
shown are as follows:
MAC-Address Displays the MAC address of the station's radio.
Network States the name of the wireless network.
Device Name Shows the name of the station.
Last IP States the most recent IP address of the station as seen by the Radio.
Signal Displays the received signal strength from the Client e.g. -26 dBm.
Signal/Chains Shows the received signal strengths from the station on each antenna e.g. -42, -26 dBm. The
value of -95 dBm is taken to mean “no antenna” if the radio has only 2 antennas.
Noise Displays the received noise power at the AP.
TX Rate Shows the transmit bit rate from the AP towards this Client.
RX Rate Shows the receive bit rate at the AP from this Client.
TX-CCQ Indicates the wireless connection quality.
9.6 System
This section shows the Netwave Product name, Firmware Version, Kernel Version, and Local Time.
Figure 8: System parameters.
9.7 Memory
Here, the Total Available and Free memory are shown.
Figure 9: Total Available and Free Memory.