Instruction Manual

INS_NetWave_REV– 06/10/13 PAGE 30
INSTALLATION AND OPERATION MANUAL NETWAvE
TECH SUPPORT: 1.888.678.9427
10.4 Services
In the System» Services page, you can configure the Ping Watchdog and the Auto Reboot.
10.4.1 Ping Watchdog
Figure 27: Ping Watchdog settings in the System » Services page.
Ping
Watchdog
Configures the device to ping to a remote IP address and reboot if the connection is
lost. It is disabled by default.
IP Address
to Ping
Sets the remote IP address to ping e.g. 192.168.10.10 or 8.8.8.8.
Ping Interval Specifies the time between successive pings, the default being 5 seconds.
Startup
Delay
Sets the time delay after the device finishes rebooting, before running the Ping
Watchdog, the default being 60 seconds.
Failure Count
to Reboot
Specifies the number of failed pings before the device reboots automatically.
10.4.2 Auto Reboot
Figure 28: Auto Reboot settings in the System » Services page.
Auto Reboot Allows the device to reboot itself automatically, disabled by default.
Mode Chooses the Auto Reboot mode by Time or by Number of Hours.
Time Sets the time of day to reboot if the Mode is by Time.
Number of
Hours
Sets the delay as an integer number of hours after each reboot, if the Mode is by
Number of Hours.