Manualshelf

Instruction Manual

ManualsBrandsComnet ManualsWireless TransmissionIndustrially Hardened Narrow Bandwidth Wireless Radio, Supports distances up to 2 mi/3.2 km
31323334353637383940
INS_NetWave_REV– 06/10/13 PAGE 32
INSTALLATION AND OPERATION MANUAL NETWAvE
TECH SUPPORT: 1.888.678.9427
Trap
Figure 30: SNMP trap configuration.
Enable SNMP Trap Allows the SNMP agent to notify the SNMP manager of events.
SNMP Trap IP Address Sets the IP address of the SNMP manager which receives the trap
messages.
SNMP Trap Port Sets the port number.
10.6 Reset Button
The reset button is a physical hardware button on the AP hardware board. Depending on how
long the button is pressed, you can reboot the board or reset it to factory default. First make
sure that the power is on and wait a minute for the board to finish starting up. The following table
shows the duration of the button press and the corresponding action.
Button Press Duration Effect
0 - 3 seconds Reboot
4 - 30 seconds Reset to factory default