Instruction Manual

INS_NetWave_REV– 06/10/13 PAGE 37
INSTALLATION AND OPERATION MANUAL NETWAvE
TECH SUPPORT: 1.888.678.9427
Protocol – DHCP client
The Dynamic Host Configuration Protocol (DHCP) is a standardized networking protocol used
by servers on an IP network to allocate IP addresses automatically to client devices.
Hostname to send
when requesting
DHCP
Specifies the name of this device as seen by the remote DHCP server.
Protocol – PPTP
The Point-to-Point Tunneling Protocol (PPTP) is a method for implementing virtual private
networks. PPTP uses a control channel over Transmission Control Protocol (TCP) and a Generic
Routing Encapsulation (GRE) tunnel operating to encapsulate Point-to-Point Protocol (PPP)
packets.
VPN Server Specifies the IP address of the remote PPTP server for the virtual private network
(VPN).
PAP/CHAP
username
Sets the username for the Password Authentication Protocol (PAP) or the Challenge-
Handshake Authentication Protocol (CHAP).
PAP/CHAP
password
Sets the password for the PAP or CHAP.
Configure
PPTP IP
settings
Upon clicking the “Configure...” button, the PPTP Common Configuration page
would be displayed. The protocol DHCP client or Static address can be selected. The
corresponding options are explained within this section "Common Configuration"
Protocol – PPPoE
The Point-to-Point Protocol over Ethernet (PPPoE) is a network protocol for encapsulating PPP
frames inside Ethernet frames. Most DSL providers use PPPoE, which provides authentication,
encryption, and compression.
The options PAP/CHAP username and PAP/CHAP password have been explained earlier.
Access
Concentrator
Identifies the PPPoE server. Leave empty to autodetect.
Service Name Specifies the PPPoE service name. The server will accept clients which send an
initialization message with the service name that matches the server's configuration.
Leave empty to autodetect.