Quick Start Guide

INS_NW1_NW2_QS_REV– 07/7/15 PAGE 7TECH SUPPORT: 1.888.678.9427
TYPICAL POINT-TO-POINT CONFIGURATION
TYPICAL POINT-TO-MULTIPOINT CONFIGURATION
NOTE: NW1/M and NW2/M Multipoint nodes will need to have the Wireless Mode set to either AP or Client (default is Client).
And the IP addresses will need to be all set to different addresses (default address is 192.168.10.101). Once this is
done, all the clients will connect to the multipoint AP with all other settingst kept at default.
PIM
or other
PSE device
PIM
or other
PSE device
PIM
or other
PSE device
NW1
(Set to Client)
IP
Camera
NW1
(Set to Client)
IP
Camera
NW1
(Set to Client)
IP
Camera
PIM
or other
PSE device
NW1
(Set to Client)
IP
Camera
PC NVR
Cat5 Cable
10/100Mbps
ComNet Gigabit
Managed Switch
with 30W PoE+
NW1
(Set to Access Point)
PoE
PC NVR
Cat5 Cable
10/100Mbps
ComNet Gigabit
Managed Switch
with 30W PoE+
NW1
(Set to Access Point)
(IA870 option recommended)
PoE
QUICK START USER GUIDE NW(1,2)
Power
NW1
(Client)
NW1
(Access Point)
POINT-TO-POINT TOPOLOGY UTILIZING DUAL PORTS
ComNet Managed
Switch with 30 W PoE
Connected to Network
IP Camera
IP Camera
Power
P1
P2
PoE
10/100 Mbps
Ethernet
PoE
Ethernet
Ethernet
Ethernet
PIM or other
PSE device
Note: Port 2 does not provide power like the NW7 or NW8.