Quick Start Guide

INS_NW7_NW7E_QS_REV– 07/7/15 PAGE 7TECH SUPPORT: 1.888.678.9427
QUICK START USER GUIDE NW7[E]
TYPICAL POINT-TO-POINT CONFIGURATIONS
TYPICAL POINT-TO-MULTIPOINT CONFIGURATION
NOTE: NW7 and NW7E Multipoint nodes will need to have the Wireless Mode set to either AP or Client (default is Client). And
the IP addresses will need to be all set to different addresses (default address is 192.168.10.101). Once this is done, all
the clients will connect to the multipoint AP with all other settingst kept at default.
NW7
(Client)
NW7
(Access Point)
ComNet Managed
Switch with 30W PoE
Connected to Network
CNGE1IPS or
any PSE device
IP Camera
PoE Camera
Power
P1
P2
PoE
1Gbps
Ethernet
PoE
Ethernet Ethernet
PoE
Ethernet
PoE Camera
.
.
.
.
.
.
PoE Camera
NW7
(Access Point)
NW7
(Client)
ComNet Gigabit
Managed Switch
providing 30W PoE
Connected to Network
ComNet Gigabit
Managed Switch
providing 30W PoE
P1 P1
PoE
1Gbps
Ethernet
PoE
Ethernet
PoE
Ethernet
PoE
1Gbps
Ethernet
PC NVR NW7/IA870
(240 Mbps
Access Point)
NW1 (Client)
PoE
PIM or other
PSE device
Power
IP Camera
Ethernet Ethernet
NW1 (Client)
PoE
PIM or other
PSE device
Power
IP Camera
Ethernet Ethernet
NW1 (Client)
PoE
PIM or other
PSE device
Power
IP Camera
Ethernet Ethernet
P1
PoE
1Gbps
Ethernet