Instruction manual

!
i
put the regulator back in place, turning it counter-clockwise as in
Fig. 11 until the burrs touch and replace the 3 screws.
10.4. Accessing the burrs
Follow the instructions in 10.3. in order to remove the grind regula-
tor, removing the 3 screws as explained in Fig. 10. Once this is done,
you will have to manually turn the upper burr holder clockwise to
remove it from its housing as in Fig. 12
After changing the burrs, assemble the upper burr holder by threa-
ding it counter-clockwise, replace the grind regulator (6) and follow
the instructions as shown in Fig. 10 & 11.
11
Safety measures
NOTE: The manufacturer cannot accept responsibility for any
damage caused by improper use of the machine or failure to
respect the safety measures indicated below.
Users are asked to pay careful attention to the following
indications:
Additional safety elements incorpated into our grinder models:
• Hand protector located in the doser in order to avoid ngers
accidentally getting caught in the grinding burrs
• Special xing screw to hold the hopper in place
• The coffee grinder should only be used for grinding coffee
beans.
• Do not use the machine to grind other types of foods such as
nuts, dried fruits or to fine-grind granulated foods such as sugar,
etc.
• Do not allow minors or disabled people to use the machine.
• Any other use of the machine will be considered improper and
dangerous.
• Do not allow liquids to come into contact with the internal or
external surfaces of the machine at any time, except for those
parts that have been expressly referred to in the “CLEANING”
section. If, for any reason, this should occur, immediately disconnect
the machine from the power supply and dry all surfaces carefully.
Should it be necessary to access the internal parts of the machine,
where the electrical components are located, take the machine to
your local technical service.
• In the event of any broken components or intervention, we
recommend that you contact your local technical service, who will
repair or replace the part, guaranteeing the maintenance of the
safety standards.
• Replacement of the main power cable of any grinder model
should only be done by an authorized supplier.
Fig. 12
Fig. 11
Unthreading
direction
Threading
direction