Operating instructions

STUDER Innotec COMPACT
COMPACT V6.4 16/85
4.2 Light Emitting Diodes (LED)
LED Marking LED lit LED blinks
1 AC IN
Voltage
corresponding to
self-adjusted
values is at the AC
IN input.
A voltage outside the self-adjusted
values is at the AC IN input, or the
COMPACT is in synchronization
phases
2 CHARGER
Battery charger is
working
The battery charger is locked OFF
(see chap. 4.6) or provisory out of
order. In that last case it will restart
within 10 seconds
3
SOLAR
CHARGE
Connected solar
modules are
delivering energy
4 Program
Program mode for
Aux. Contact
5
Contact
active
Auxiliary Contact is
activated
6
Contact
manual
Aux. Cont.
manually activated
7 TRANSFER
Transfer system is
active. In- coming
voltage is being
sent directly to AC
OUT outlet
Transfer (bypass) is disabled (see
chap. 4.7)
8 AC OUT
There is a voltage
at the AC OUT
outlet
The Inverter is in Standby-Mode
9 INVERTER Inverter is working Forced Inverter Mode (see chap. 4.5)
10 Over Temp.
For the time being
the COMPACT is
out of service
because of
overheating.
11 Overload
The COMPACT is
out of service
because of
overload or short-
circuit
12
Batt.
Low/High
Battery voltage is
too low
Battery voltage is or was to high
13 OFF
COMPACT is
turned off. Turning
it back on is only
possible manually.
COMPACT is for the time being
turned off. Turning it back on will
follow automatically !
14 EQUALIZE
Battery equalizing
is set
15–18
State of charge of
the battery
LED 15 – Absorption time is running