User manual

CompAir BroomWade Limited
page 38
1.7 Alarms and Shutdown Trips
1. If an alarm condition occurs and service
attention is required the appropriate alarm
indicator will flash.
2. If a trip condition occurs the compressor will
stop and the appropriate trip indicator will
flash. This can occur any time after the
compressor has been started. See para 1.9
‘Control panel indicators’.
3. The oil temperature alarm and oil
temperature trip conditions are shown by
indicator (L2) flashing. Indicator (L2) will flash
slowly for an alarm condition and the
compressor will continue to run. Indicator (L2)
will flash quickly for a trip condition and the
compressor will shut down immediately.
4. The oil temperature alarm level is
automatically set 10°C below the
programmed oil temperature trip level. See
para 2 ‘Program mode’.
B1 View
B2 Start
B3 Stop
B4 Plus
B5 Minus
B6 Reset
D1 Display
E Emergency Stop Button
L1 Pressure
L2 Temperature
L3 Hours Run
L4 Hours Onload
L5 Air Filter Alarm
L6 Motor Fault
L7 Auto/Remote Start
L8 Running
L9 Power On
CONTROL PANEL
P1 bar
T1 °C
P2
T1 °C
P1 bar
P2
L1
D1
B1
B2 E
B3
B4
B5
B6
L2
L3
L4
L5
L6
L7
L8
L9