Wireless Access Point Fast Installation Guide AP5541 • Wi‐Fi Network set up • Cable network set up 1
LAN Options Wireless Wi‐Fi Wireless LAN Wired Ethernet LAN Reset Power Adapter +12V DC Power RJ45 WPS Ethernet cable 2
Inside the Box 1 AP5541 One Power Adapter One Ethernet cable 3
Power Connection 2 Plug the power cord into an AC power outlet and the other end of the power cord into power port of AP5541. Every time AP5541 is turned on, it takes about 2 minutes to find and lock the Mesh Wi‐Fi.
Wireless LAN Connection For Configuration Manager Access 3 Check the AP5541 label to find out the basic setting of Wireless Wi‐Fi SSID and password. LED Check the AP5541 LED status. The AP5541 front panel LED indicators provide the status information for power, communications, and errors. If AP5541 is power on and work function LED should be solid white.
Wireless LAN Connection For Configuration Manager Access 3 Go to the device you wish to connect. Open your device’s Wi‐Fi settings (make sure Wi‐Fi is turned on). Refresh the "Network and Internet" window to select and connect to the AP5541 SSID name printed on the label Enter the password printed on the label and press "Next" for Wi‐Fi connection. You can access the AP5541 configuration manager through http://192.168.200.1.
Wired Ethernet LAN Connection For Configuration Manager Access 4 User can easily connect any PC RJ45 Ethernet port directly to the AP5541 Ethernet port to access the configuration manager through http://192.168.200.
AP5541 Configuration Manager (CMGR) 5 The AP5541 Configuration Manager (CMGR) allows you to change and view the settings on your AP5541. You can reach the configuration manager at http://192.168.200.
Complete AP5541 Configuration Manager (CMGR) 6 After logging into the management system, CMGR allows you to change and view the settings on your AP5541. Congratulations! Your wireless access point has been set up. If you have any problems, please follow the troubleshooting instructions to troubleshoot. IP address If your Wi‐Fi is already connected to the network or device, but still can’t connect or access to the internet. Please check/change PC IP address setting to auto let DHCP auto assist IP.
Mesh setting 7 First make sure your cable modem is able to connect to the internet, press the cable modem and AP5541 WPS button at the same time or in a 60 second window, wait for 5‐10 second to complete the Mesh network setting. If Wi‐Fi LED is blinking red light, this means AP5541 is scanning and trying to connect to the Mesh network.
Front Panel LED Behavior The AP5541 front panel LED indicators provide the following status information for power, communications, and errors: LED Status Description White On Off Device is power‐on Device is power‐off Yellow Flashing Default setting Red On Flashing Mesh network is off server / Mesh network can’t accesses IP address.
Troubleshoot If the device is not working properly, please check troubleshoot below. 1. Check electrical outlet is properly plugged into the AP5541 and the device is power on . 2. Check LED light status on the device is working properly. For more information check LED behavior. Power light is off • Check the AP5541 is properly plugged into the AC electrical wall outlet. If still not working, change another electrical outlet or make sure electrical outlet is work properly.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
