User Manual

65 Text Entry
Symbol Input
To input symbol(s), two menus are available: Symbol input
menu and Multi symbol input menu.
By using the Symbol input menu, you can quickly select a
symbol and return to text editing, while in the Multi symbol
input menu, you can select up to 12 symbols at a time.
Symbol input menu
To open the Symbol input menu, press the key in any
input modes.
The Symbol input menu is displayed as follows:
☛ Highlight the line in which the symbol you want is
located. You can move the highlighted line by using
the 4-way navigation key.
☛ Find the keypad number displayed above the symbol
and press the key. The temporary symbol menu
disappears after inserting a symbol.
2 You can cancel the temporary symbol menu by pressing
the key.
Multi symbol input menu
To open the Multi symbol input menu, press and hold
the key in any input modes.
Input one or more symbols using the same operation as in
the Symbol input menu as described in
Symbol input
menu
above. To complete symbol input and return to text
editing, press SK1 (OK). To cancel symbol input, press SK2
(CANCEL).
Options
☛ Press Options on the Text entry field and the
following functions are available.
Symbol input
menu
Multi symbol input
menu
No Settings
1 Insert object Inserts the symbols or pictographs.
1 Insert
symbols
(Refer to Symbol Input in this
section.)
2 Insert
pictograph
Inserts the pictographs.
2 Input method Selects the input mode.
1T9 (Refer to Multitap Text (ABC) Input,
Numeric Input and T9® Text Input
in this section.)
2 ABC
3 123
3 Copy/cut/other You can copy, cut, delete or replace a
block of text.
2 Before performing this function,
move the cursor to the starting
point using the 4-way navigation
key to specify the starting point
on the text entry field.
2 Pressing and holding the key
also starts this function.
2 After the block of text is
selected, pressing SK1 to copy
or SK2 to cut the block is
available.
2 You can also use Options to
choose the functions from
Copy, Cut, Delete, Replace or
New selection.
2 Pressing Options and Replace
allows you to replace the
selected text by the text on the
clip board.