User's Manual

symbols corresponding to the selected WEP.
Select Key as transmit 1 - 4.
Check here to enable 802.1x authentication
Default is “Enable.
Select EAP type Default is “TLS(EAP-TLS)?
Show the Properties when you can connect to
Access Point with 802.1x authentication
?Data encryption (WEP Enabled)
Click here to enable data encryption.
?The Key is provided for me automatically:
Check here if you can obtain WEP key automatically from AP. Almost
case this function is used with 802.1X function. Default is "Enable".
?Network Key (WEP key):
Enter the ASCII characters and symbols that correspond to the mode
selected.
64 bits (ASCII)
5-digit ASCII characters or symbols can be entered in "Network Key".
128 bits (ASCII)
13-digit ASCII characters or symbols can be entered in "Network
Key".
64 bits (HEX)
Hexadecimal 10-digit English letters and numerals can be entered
in “Network Key.?Letters and numerals that can be entered are 0-9
and A(a) - F(f).
128 bits (HEX)
Hexadecimal 26-digit English letters and numerals can be entered
in “Network Key.?Letters and numerals that can be entered are 0-9
and A(a) - F(f).
?Key Index:
This becomes enabled when WEP is selected. Select 1 - 4.
153
Toshiba Pocket PC e800/e805 User’s Guide
?Enable network access using IEEE 802.1X:
Check here to enable 802.1x validation function.
?EAP type:
Select protocol for using 802.1x validation function.
TLS (EAP-TLS)
Transport Layer Security (TLS) protocol used by Windows 2000