User's Manual

10
BATTERY INFORMATION
Your phone comes with a partially charged, rechargeable Li-ion Battery so that you can use the
phone immediately after it is activated.
Installing the Battery.
To put the battery into your phone :
1. Remove the battery compartment cover of the phone by sliding it down.
2. Put the battery pack into the battery cradle.
3. Replace the battery compartment cover by sliding it up towards the phone.
4. Before use, charge the battery pack for at least 3 hours.
Charging the Battery.
You can tell whether or not your battery needs to be recharged by checking the upper-right
corner of your phone’s display.
When the battery charge level gets low, the battery sensor will let you know by blinking the
battery icon and sounding a warning tone. If the battery level gets too low, the phone will turn
off automatically. Unfortunately, if this happens you’ll lose whatever you were just doing,
including dropping your call. Watch the battery strength icon and make sure your battery is
adequately charged.
Charging with the Traveler’s Charger.
Use only Compal Electronics approved traveler’s chargers with your phone. Use of any
unauthorized accessories may be dangerous and will invalidate the phone warranty if said
accessories cause damage or a defect to the phone.
To charge the battery using the Traveler’s Charger :
- Plug the power cord of the charger into a wall outlet.
- Insert the connector of the charger at the bottom of the phone.
- Note) Be sure that you put the connector of the charger into the phone correctly.
Failure to do so may causes damages to the phone.