User's Manual

10
A completely discharged standard sized battery charges full in approximately tbd hours.
Leaving your phone powered on during charging or charging two batteries simultaneously will
increase charge times. Leaving the battery connected to the charger after it has been fully
charged will not harm the battery.
? WARNING
After the battery is fully charged, the battery can be discharged. If the charger is
connected to your phone for over 3hrs, please pull the plug from the phone and recharge
the battery even if the battery is fully charged.
Turning your phone on and off.
When you’re ready to turn on your phone, press and hold “END( )” until the display is turned
on and the phone makes the sound. When the phone has found a signal, the “ ” icon appears.
Once the phone is turned on, it enters Standby mode and you are able to make and receive calls.
To turn your phone off, press and hold “END( )” until the display is turned off and the phone
makes the sounds. Then the display will go blank. When the phone is turned off, nothing is
displayed on screen.
Note: If “END( )” is pressed for less than one second, the phone will not be turned off. This
function prevents your phone from being turned off accidentally.
Standby Mode.
Standby is the most basic state of your phone. The phone goes into standby mode soon after you
turn it on, or whenever you briefly press “END( )”. When your phone is in Standby Mode,
you will typically see the banner (that’s the message displayed when you turn on your phone). If
you enter a phone number, you press “SEND( )” to complete the call, or press “STO ( )” to
save it in the internal phone book.
Power Save Mode
Your phone comes with a Power Save feature that will automatically be activated if your phone
is unable to find a signal after 15 minutes of searching. While this feature is active, the phone’s
battery power is conserved.