User's Manual

The next time you boot up the Notebook, the BIOS will attempt
to load the values you saved in Non-Volatile memory. If these
values cause the system boot to fail, reboot and press [F2] to enter
the Setup program. Once in Setup, you can try to change the
values that caused the system boot to fail. If the problem persists,
load the default values (see Get Default Values below).
If you attempt to exit the Setup program without saving your cha
nges,
the program will prompt you with a message asking if you want to
save your changes before exiting.
Exit Discarding Changes
This option can be used if you do not want to save the changes
you have made to the Setup program. The default is set to No. If
you have made changes to the fields other than system date,
system time and password, the system will ask for confirmation
when choosing Exit Discarding Changes.
The system reboots using the original Setup values.
Load Setup Default
This option allows you to load the default values for each of the
parameters on the Setup Menus. When this option is selected, a
confirmation message appears.
The system will remain in Setup after either selection.