Manual

Fig. Y
3 2
BEVEL CROSSCUTTING (FIG. AA)
0°-45 ° BLADE BEVEL & 90° MITER ANGLE
This cutting operation is the same as crosscutting except
the blade is at bevel angle other than 0°.
1. Adjust the blade (1) to the desired angle, and tighten the
blade bevel lock knob.
2. Tighten miter lock handle at 90°.
Fig. AA
2
COMPOUND MITER CROSSCUTTING (FIG. BB)
0°-45 ° BLADE BEVEL & 00-45 ° MITER ANGLE
This sawing operation is combining a miter angle with a
bevel angle.
WARNING - Always work to the left side of the blade
during this type of cut. The miter gauge (3) must be in the
left side miter gauge groove. It cannot be used in the right
side groove unless the miter angle is very sharp, as it will
interfere with the blade guard.
1. Set the miter gauge (3) to the desired angle. Use only
the left side groove (2).
2. Set the blade (1) bevel to the desired angle.
3. Carefully push the miter gauge to begin the cutting
operation.
Fig. BB
MITERING (FIG. CC) 00-45 ° MITER ANGLE
This sawing operation is the same as crosscutting
except the miter gauge is locked at an angle other
than 90 °.
WARNING - Always work to the left side of the blade
during this type of cut. The miter gauge (3) must be in
the left side miter gauge groove. It cannot be used in
the right side groove unless the miter angle is very
sharp, as it will interfere with the blade guard.
1. Hold the workpiece (2) firmly against the miter
gauge (3).
2. Feed the workpiece slowly into the blade (1) to
prevent the workpiece from moving.
Fig. CC
2 1
3
USING WOOD FACING ON THE RIP FENCE
(FIG. DD)
When performing some special cutting operations,
You can add a wood facing (1) to either side of the rip
fence (2).
1. Use a smooth straight 3/4" thick wood board (1) that
is as long as the rip fence.
2. Attach the wood facing to the fence with wood
screws (3) through the hole in the fence. A wood
fence should be used when ripping material such
as thin paneling to prevent the material from
catching between the bottom of the fence and the
table.
19