Manual

KNOW YOUR SAW cont.
Electrical Connection
Your saw has a precision-builtelectricmotor. It should be connectedto a power supply that is
120 volts, 60 Hz AC only (normal household current). DO NOT operate this tool on direct
current (DC). A substantialvoltage drop willcause a lossof power and the motorwilloverheat,
Ifyour tool does not operate when plugged into an outlet, double-check the power supply.
recommended for use with thistool. Any such alteration or modificationis a misuse
and could result ina hazardous condition leading to possible serious personal injury.
I Z_WARNING: To prevent accidental starting that could cause possible serious I
I
personal injury, ALWAYS assemble all parts to your saw BEFORE connectingit to the
I
power supply. The saw should NEVER be connected to a power supply when you are
assembling parts, making adjustments, installing or removing blades, or when not in use.
Your compound miter saw has been factory assembled and adjusted. The blade, miter
lock handle, dust guide and dust bag are the only parts that have to be installed.
TO INSTALL MITER
LOCK HANDLE (See Fig. 9)
1. Place thethreadedstudon the
end of the miter lockhandle into
the threaded hole in the control arm.
2. Turn clockwise to tighten.
TO INSTALL DUST BAG
(See Fig. 10)
This miter saw comes witha dust bag and
a vac adapter to help you keep thework
area clean. The dust bag is idealfor smaller
jobs.
Attachingthe Dust Bag
1. Placetheopenend ofthedust bag over
theexhaustport in the upperbladeguard.
Attachingthe MacAdapter
The vac adapter can be used withmost
wet/dry vacs.
1. Place the end of the vac adapter marked
INSERT over the exhaust port in theupper
blade guard
2. Turn the adapter so theopen end is facing
down or towardthe rearof the saw.
19