Installation guide

68
MICS-XC 4.1 Programming Record P0902615 Issue 03
 Handsfree
Select whether Handsfree will be available to a telephone.
 HF answerback
Select whether a user can automatically answer a voice call without lifting the receiver or
pressing the Handsfree/Mute button. It is always turned off for an M7100 telephone.
 Pickup grp
Select one of nine pickup groups to assign this telephone to. Any user in a pickup group can
answer calls to any other telephone in their group using the Call Pickup - group feature
(ÄàÞ). Choose None to disable the feature for this telephone.
 Page zone
Select one of three page zones to assign this telephone to. Choose None to prevent pages at
this telephone.
 Paging
Select whether paging announcements can be made from this Norstar telephone.
 D-Dial
Select whether you can call the Direct-dial telephone from this telephone using the Direct-dial
digit.
 Priority call
Select whether to allow this telephone to interrupt calls or to override Do Not Disturb at another
Norstar telephone. A priority call (Äßá) can be refused by the person whose call
you are trying to interrupt using Do Not Disturb (Ä¡Þ). A priority call cannot be
blocked by a person whose telephone is already in Do Not Disturb.
 Hotline
Select whether a telephone number will be dialed automatically when a user lifts the receiver or
presses ©. Choose Intrnl to enter an internal Norstar telephone as the hotline. Choose
Extrnl to enter an external telephone as the hotline.
 Aux. ringer
Select whether an auxiliary ringer (if installed) will ring for incoming calls at this telephone.
 Allow redirect
Select whether to allow this telephone to redirect its lines.
 Redirect ring
Select whether a telephone rings briefly when a call on one of its lines is redirected by the Line
Redirection feature (Ä¡Ý).
 ATA settings
Analog telephones or other devices which are connected to the ICS using an Analog Terminal
Adapter (ATA) may need the additional programming found under this sub-heading.
 ATA ans timer
Select the number of seconds for the delay between the last digit you dial on a device connected
to an analog terminal adapter (ATA) and when the analog device is ready to receive DTMF tone
from the far end analog device.
 ATA use
 MsgIndicate
Select the type of message indicator that is used by a telephone connected to the ICS by using
an analog terminal adapter (ATA).
 Name
A programming section that lets you assign names to telephones up to a maximum of 7
characters.
 User prefernces
A programming section that lets you program the user admin features, such as external
autodialers, language choice and display contrast, which personalize the operation of the
users set.
 Model
Allows you to pre-program the model of Norstar set which will use this DN.
 Button prgrming
Lets you program the buttons with internal and external autodialers and/or programmed
feature keys.
 User speed dial
Section where user speed dialers can be programmed.
 Call log optns
Select whether the set will log all calls, no calls, or only unanswered calls.
 Dialing optns
Select standard dial, pre-dial or automatic dial.
 Language
Choose the display language: English, French or Spanish.
 Display cntrst
Select a display contrast level.