Installation guide

75
P0902615 Issue 03 MICS-XC 4.1 Programming Record
 COS pswd #00
Indicates the number of the password to which you are assigning information.
 Pswd 00
Enter a six-digit password.
 User flt
Assign a restriction filter to the Class of Service password.
 Line flt
Select whether a Class of Service password will use the default line filter or a different line filter
(enter the two-digit filter number).
 Remote pkg
Select whether a Class of Service password will use the default remote package or a different
remote package (enter the two-digit remote package number).
 Call log pswds
A programming section that allows you to clear any Call Log password programmed with the
Call Log feature.
 Show set:_
Enter the DN of the telephone you want to program.
 Log pswd
Erase the call log password for this telephone.
 Programing pswds
In this section you can create your own password rather than use the default.
 Installer
Enter the new installer password which gives you access all the programming settings.
 SysCoord+
Enter the new system coordinator password which gives you access to selected programming
settings.
 Sys coord
Enter the new system coordinator password which gives you access to everyday programming
settings.
 Basic
Enter the new basic password which gives you access to the most commonly used programming
settings.
 Reg pswd.
Enter the new registration password which lets you register portable telephones to the system.
 Hospitality
A programming section that allows to create Hospitality services passwords if required, rather
than use the defaults.
 Desk pswd
Enter the new Desk password which gives access to all Hospitality services programming
settings.
 Cond pswd
Enter a Condition password which gives certain employees access to the Room condition
programming settings in Hospitality services.
Time&Date
A programming section that lets you set the system's clock to the correct time and date.
System prgrming
A programming section that lets you change system-wide settings.
 Hunt groups
A programming section that lets you set up incoming calls on a specific DN to be routed to a
group of sets.
 Show group:_
Enter the DN of the telephone you want to program.
 Member DNs
Enter the DN of the telephone you want to add to the group.
 Line assignment
Allows you to assign or unassign a line to a particular hunt group.
 Mode:
Allows you to determine how an incoming call will be handled by the hunt group.
 Hunt delay:
Select a delay value to determine how long a set rings before the call moves on the next member
set.
 If busy:
Allows you to determine how an incoming call is to be treated when all hunt group member sets
are busy.
 Q Timeout:
Allows you to set the number of seconds the incoming call remains in the hunt group call queue
before it is offered to the overflow position.
 Overflow:
Enter the DN of the set you want the hunt group overflow calls to be presented.