Installation guide

Basic system procedures 4-9
Starting Meridian Mail
Standard 2.0 Meridian Mail Mini and Enhanced Card Option May 2000
Installation and Maintenance Guide
Starting Meridian Mail
Introduction
Meridian Mail does not start automatically; you must start it
manually under the following circumstances:
• whenever you use the System Installation and Modification
utility or to perform troubleshooting and maintenance
procedures
• whenever you have courtesied the system down to perform
system procedures
• whenever the Meridian 1 PBX is turned off, as in the event
of a power failure
Restarting the system
To restart the system, follow these steps.
Step Action
1 Enable the data ports for the console and the AML.
(Refer to
“Enabling and disabling the console and AML data ports”
on page 4-5.)
2Enter
AX
<Return> to view the Meridian Mail screen.
3 Do you have a Tandberg tape drive?
• If yes, verify that the tape drive’s power is on.
• If no, continue.
4 Wait until the system has loaded and the logon screen is
displayed (approximately four minutes).
If this does not happen, refer to Chapter 5,
“Troubleshooting and maintenance.”