Installation guide

4-20 Basic system procedures
Changing the default Meridian Mail DNs
Standard 2.0 Meridian Mail Mini and Enhanced Card Option May 2000
Installation and Maintenance Guide
• After the final prompt listed in the procedure, enter * * * *
to exit the overlay.
For more information on the Meridian 1 overlays used in these
procedures, refer to X11 Software Guide Including
Supplementary Features.
Changing the Voice
Messaging DN
Changing the Voice Messaging DN is not as straightforward as
changing one of the other service DNs, since so many other
entities within the Meridian 1 PBX refer to this DN, and each of
these must be changed to refer to the new Voice Messaging DN.
This procedure assumes that the Voice Messaging DN is the DN
assigned to the virtual ACD agents that answer calls to Meridian
Mail.
To change the Voice Messaging DN, follow these steps.
Step Action
1 Courtesy down Meridian Mail. (Refer to page 4-8.)
2 Disable the console and AML data ports. (Refer to
“Enabling and disabling the console and AML data ports”
on page 4-5.)
3 Print the following reports.
a. Print a report for each type of telephone set on the
switch, following the prompts in “Printing a
telephone set report” on page 4-25.
b. Print a report for each telephone model on the switch,
following the prompts in “Printing a telephone model
report” on page 4-25.
c. Print an ACD queue report, following the prompts in
“Printing an ACD queue report” on page 4-25.
d. Print a hardware location report for card 10, following
the prompts in “Printing a hardware location report” on
page 4-25. The devices on this card are the virtual
ACD agents that answer calls to Meridian Mail.