Installation guide

4-22 Basic system procedures
Changing the default Meridian Mail DNs
Standard 2.0 Meridian Mail Mini and Enhanced Card Option May 2000
Installation and Maintenance Guide
Changing a hardware
location DN
To change a hardware location DN, follow these steps.
8 Night call forward (NIT1) in the Customer Data Block (in
LD 15 of the Option 11) may have been previously set to
forward to Meridian Mail. If it was set to the old Voice
Messaging DN, change it so that it refers to the new DN.
Refer to
Option 11 Technical Reference Guide.
9 Log on to Meridian Mail.
10 From the Main Menu, choose
3 Voice Administration
→
3 Voice Services Administration
→
1 Voice Service DN Table
11 Select the Voice Messaging DN and select [View/
Modify].
12 Change the value of
Access DN
to the new Voice
Messaging DN, and select the [Save] softkey.
13 Return to the Meridian 1 PBX and enable the console
and AML data ports. (Refer to Enabling and disabling the
console and AML data ports on page 4-5.)
14 Start Meridian Mail. (Refer to page 4-9.)
Step Action
Step Action
1 Log on to the Meridian 1 PBX. (Refer to “Logging on to
the Meridian 1 PBX” on page 4-3.)
2 Disable the hardware location, following the prompts in
“Disabling a hardware location” on page 4-28.
3 Change the hardware location’s DN, following the
prompts in “Changing a hardware location’s DN” on page
4-29.
4 Return to Meridian Mail and log on.
5 From the Main Menu, choose
5 System Status and Maintenance
→
3 DSP Port Status.