Installation guide

Basic system procedures 4-23
Changing the default Meridian Mail DNs
Standard 2.0 Meridian Mail Mini and Enhanced Card Option May 2000
Installation and Maintenance Guide
Changing the other
Meridian Mail DNs
The following procedure allows you to change the other service
DNs defined during software installation. It should not be used
to change the Voice Messaging DN.
For new DNs to function correctly, you must define them in two
places: on the Meridian 1 PBX, and on the Meridian Mail
system administrator’s terminal.
To change the other Meridian Mail DNs, follow these steps.
6 Select [Disable Port] at the prompt, and enter the
number of the DSP port you want to change.
7 Return to the System Status and Maintenance Menu and
choose
4 Channel Allocation Table.
8 Change the SCN on the port you just disabled to the DN
you just assigned on the PBX.
9 Return to the System Status and Maintenance Menu and
choose
3 DSP Port Status.
10 Select [Enable Port] and, at the prompt, enter the
number of the DSP port you want to change.
11 Return to the Meridian 1 PBX and enable the hardware
location, following the prompts in “Enabling a hardware
location” on page 4-28.
Step Action
Step Action
1 Courtesy down Meridian Mail. (Refer to page 4-8.)
2 Disable the console and AML data ports. (Refer to
“Enabling and disabling the console and AML data ports”
on page 4-5.)
3 Log on to the Meridian 1 PBX. (Refer to “Logging on to
the Meridian 1 PBX” on page 4-3.)