Installation guide

8-8 Networked systems
Configuring the modem
Standard 2.0 Meridian Mail Mini and Enhanced Card Option May 2000
Installation and Maintenance Guide
Note:
Older versions of the Ven-Tel modem might have
another switch labeled SW3. It should have all its
switches set to the off position. See your Ven-Tel user’s
manual for the location of these switches.
3 Plug the modem and terminal into an appropriate AC
receptacle and turn them on.
4Enter
at&f
<Return> to reset the model to the factory
default values.
The screen displays OK.
5Enter
at&d3
<Return> to enable DTR-initiated reset.
The screen displays OK.
6Enter
at&w
<Return> to save the configuration.
The screen displays OK.
7 Turn the modem off, wait 10 seconds, and turn the
modem on again.
8Enter
at\s
<Return> to verify the modem settings.
They should read as follows:
For EC2400-33 Rev. 5.2:
\A0, %A0, B0, &C1, \C0, %C1, &D3, \D0, E0, F1, &G0,
\G0, \J0, &L0, M1, &M0, \N1, &P0, Q0, \Q0, &R0, \T0,
&T4, V1, \V0, X4, &X0, \X0, Y0
For EC2400-33 Rev. 6.0:
\A0, %A0, B0, &C1, \C0, %C1, &D3, \D0, E0, F1, &G0,
\G0, \J0, &L0, M1, &M0, \N1, &P0, Q0, \Q0, &R0, \T0,
&T4, V1, \V0, X4, &X0, \X0, Y0, *N0
For EC2400 Plus II Rev.4.53:
\A0, %A0, B0, *B0, &C1, \C0, %C1, &D3, \D0, E0, F1,
&G0, \G0, \J0, &L0, M1, &M0, \N1,*N0, &P0, Q0, \Q0,
#R0, &R0, *S3, \T0, &T4, V1, \V0, X4, &X0, \X0, Y0,
*A=018, 015, 001, 004
If there are any discrepancies, verify the switch settings
from Step 2 and repeat Step 4 to Step 8.
9 Turn off the modem and connect it to the Meridian 1
system according to the instructions starting on page
8-4.
10 Turn off the terminal and reconnect it to the Meridian 1
PBX.