Installation guide

Hardware installation 1-43
Connecting the LED jumper wires
Standard 2.0 Meridian Mail Mini and Enhanced Card Option May 2000
Installation and Maintenance Guide
Testing the faceplate
LEDs
To test the faceplate LEDs, follow this step.
Note: At startup, the green LED lights for about a half-second
and then goes off. After the internal hardware diagnostics are
complete, this green LED stays on if all the Meridian Mail
Enhanced Processor Card hardware passes its test. A flashing
green LED indicates that some hardware is in faulty condition.
Typically, this fault can be cleared by tightening the connection
of the SCSI drive, or the hard disk drive, or both, or by replacing
the hard disk drive, if necessary.
Step Action
1 Plug in the circuit pack in its chassis location.
Note:
After Meridian Mail is reset, it takes approximately
five minutes for the hard disk to be accessed and the
HDD faceplate LED to light.