Installation guide

2-8 System installation and modification
Using the System Installation and Modification menu
Standard 2.0 Meridian Mail Mini and Enhanced Card Option May 2000
Installation and Maintenance Guide
4 Start Meridian Mail. (Refer to “Starting Meridian Mail” on
page 4-9.)
Just above the reset switch on the Meridian Mail
Enhanced Processor Card are two LEDs (the left one is
green, the right one is amber). When the system is first
turned on, the green LED lights briefly and Meridian Mail
proceeds with its internal diagnostics and start-up
procedures.
The LED should remain unlit during the entire process—
which takes approximately four minutes—and then come
back on and remain lit. At almost the same time that the
LED lights up, the PBX prompts similar to the following
appear:
ESDA002 9 <time and date>
CSA003 9 <time and date>
a. While Meridian Mail is starting up, toggle to the PBX
terminal and verify the following:
•Time and date are correctly set.
•The AML is in auto setup mode. (See “For Release
17 systems and earlier” on page 4-5 or “For
Release 18 systems and later” on page 4-6.)
•The voice ports (hardware locations) are not
disabled. (See “Enabling a hardware location” on
page 4-28.)
b. Type
AX
and press <Return> to toggle to the Meridian
Mail terminal.
The tape drive starts reading the tape, and—after
approximately three minutes—Meridian Mail displays
the following menu:
Step Action