Installation guide

Page 92 of 206 Programming the Meridian Companion system
553-3601-220 Standard 4.00 November 1998
Changing passwords
Changing the Installer password
To enter Configuration and Administration programming, Maintenance, and
Memory Reset, you must use the Installer password
.
The default password is
‚‚‚‚ .The Installer password must have at least one digit and no more
than six digits.
1. Press ƒ••‚ to enter Configuration programming. The
display shows Password: .
2. Enter the Installer password. The display shows A. Configuration.
3. Press ^ then * until the display shows
3. Admin. Set Data .
4. Press ^ . The display shows Installer pswd. .
5. Press CHANGE
. The display shows New pswd: .
6. Enter a new one- to six-digit Installer password. Use BKSP
to correct
your entry if necessary.
ATTENTION!
You should change the Installer password after the system
is installed to protect the integrity of the settings.
To prevent unauthorized access, provide the Installer password
only to selected personnel.
ATTENTION!
Record your password.
Record any password changes in
Meridian Companion
Programming and Provisioning Record
. If you forget the Installer
password, you will not be able to enter Programming,
Maintenance, Memory Reset, or System Startup.