Installation guide

Page 126 of 206 Maintenance
553-3601-220 Standard 4.00 November 1998
Disable at once? and Disable at idle? . The softkey appears only when
the state is
Busy or Wait Idle .
The following maintenance tasks can be performed using the Administration
Terminal, as shown, or Companion Manager. For Companion Manager
instructions, refer to Companion Manager Installation and Operations Guide.
System Status
The System Status feature enables you to check the system type and state and
perform system level maintenance actions.
1. Press ƒ••‚ and enter the Installer password.
2. From
A. Configuration , press * until the display shows
C. Maintenance .
3. Press ^ . The display shows
1. System Status .
4. Press ^ . The display shows the product name ( MC ) and
protocol ( PCI ).
5. Press
STATE to see the operational state of the system, described in Table
33.
6. Press
TYPE at any point to reset the display to show the product name
and protocol, as indicated in step 4.
7. Press ^ to see the software version and release number.
8. Press ® to exit, or % to continue in Maintenance
programming.
Note: The system can be disabled if the state is
Busy , Fa i l e d , Idle ,
or
Wait Idle . Pressing DSBL shows Disable at once? on the
display. You can select either YES
(the system enters the
Disabling state), or CHANGE (you are asked whether to disable