Installation guide

Page 130 of 206 Maintenance
553-3601-220 Standard 4.00 November 1998
Wireless Terminal Number (WTN) Status
The WTN Status feature enables you to check the WTN type and status. There
are no maintenance actions available because they can be performed from the
Meridian 1 side.
1. Press ƒ••‚ and enter the Installer password.
2. From
A. Configuration , press * until the display shows
C. Maintenance.
3. Press ^ , then press * until the display shows
3. WTN Status .
4. Press ^ . Enter the WTN.
5. You can enter a number or press ^ to see the first WTN. The
display shows W followed by the four-digit WTN and the WTN type.
6. Press
STATE to see the WTN state as shown in Table 35.
Note: Pressing
TYPE at any point resets the display so it shows the card
number and type as indicated in step 3.
7. Use * and & to view other WTNs.
8. Press ® to exit or % to continue in Maintenance
programming.
Table 35 : WTN states and actions
State Meaning Possible action
Idle
The WTN is enabled but not in use.
TYPE
Disabling
The card is in the process of being
disabled.
TYPE
Fa i l e d
The WTN module has failed. handle at card level
Busy
The WTN is in use.
TYPE
Wait Idle
The card has been disabled when idle.
This WTN still has an active call. It will
be disabled as soon as the call
terminates.
handle at card level