Installation guide

Maintenance Page 139 of 206
Meridian Companion Installation and Maintenance Guide
Erasing the Administration log
1. Enter the Administration log.
2. Press ERASE
. The display shows Erase log? .
3. Press YES
. If no new events have been added since the list was entered,
the log is erased and the display shows Log is empty , then
6.Admin Log . If new events have been added since the list was entered,
the display shows Log has changed .
Responding to event and alarm messages
The alarm messages are displayed on the Administration Terminal. This is an
example of an alarm message:
Report the alarm and the time it occurred to your installer or distributor.
Responding to an alarm code
Alarm codes can take up to two minutes to be displayed on the Administration
Terminal. If the system was turned off when the failure occurred, the alarm
code appears two minutes after the system is turned on.
When you see an alarm code, follow these steps:
1. Record the alarm code.
2. To see when the alarm occurred, press
TIME .
3. To clear the alarm, press
CLEAR .
4. Determine the cause of the alarm using Table 41 on page 174.
Alarm: 51-04
TIME CLEAR